Kbox dead
|
Silver Member Username: Brampton_onPost Number: 133 Registered: Nov-06 | kbox is dead after a hard re-boot when i turn it back on it displays H1 and shows blank lines after that any ideas  |
|
Platinum Member Username: PlymouthCanada Post Number: 12543 Registered: Jan-08 | sam Thanks for this new thread! You can read those 2 threads on KBox problems: https://www.ecoustics.com/electronics/forum/home-video/607145.html https://www.ecoustics.com/electronics/forum/home-video/607019.html |
|
Silver Member Username: Brampton_onPost Number: 134 Registered: Nov-06 | DID THIS How To Fix K1-PLUS H1 ERROR If your receiver has a H1 error on your led display, this is how to fix it. 1: Down load factory file and K1 Plus loader and unzip the following. Link for Factory File: Kplus K1 PLUS FACTORY files Kpro K1 PROdigy factory files Link for Factory Loader: K1 Plus Loaders K1 Loaders 2: Connect RS232 cable to the receiver and plug the power cord from the receiver into the wall with the main power source off on the receiver. 3: Open the loader on your desk top. Locate the factory file with the browse button on the loader. 4: Now have your finger on the rear power button. Click it to the on position. When you see the H1 error appear on the display. Click CONNECT on the loader immediately. This may take a few tries but the receiver will eventually accept the file. 5: Load the latest file and reconnect the receiver back up to the your t.v. 6: Adjust all your dish settings and your good to go DOES NOT SEEM TO WORK IS NOT RESPONDING TO REMOTE ONLY SOME TIMES ANY INPUTS  |
|
Platinum Member Username: NydasPost Number: 17801 Registered: Jun-06 | Sam: Turn off kbox. Disconnect the ihub from kbox and disconnect ethernet cable from the hub. Turn off your broadband modem for at least 1 minute by removing the power to it. Make sure your kbox has the factory file loaded as above, and you have installed 2.17 with the loader cabe (old style of loading BINs), in the way described above. Reconnect Ethernet, then Ihub and then kbox to ihub. Hope you are successful. |
|
Silver Member Username: Brampton_onPost Number: 135 Registered: Nov-06 | thanks Nalin I have been trying with factory bin 1.08 which is available on Kboxhub.org which was loading ok but not solving the issue. Then i tried with basic factory 1.0 which worked AOK. Thanks Nalin Thanks Plymouth  |
|
Platinum Member Username: PlymouthCanada Post Number: 12549 Registered: Jan-08 | Thanks for your help Nalin! |
Main Forums
Today's Posts- Home Audio Forum
- Home Video Forum
- Home Theater Forum
- Car Audio Forum
- Accessories Forum
- All Forum Topics