New Kbox, I configured it and everything. For 7 , 8-10 and 3 the khub is green, the network green light flashes some time, but all I'm getting is Processing... please wait...
with a Black hub you can activate it either way, but the easier option is to load it via the PC, making sure you use the BLACK cable to do the activation and then the cream cable to run the hub with the PLUS model
Okay this guide is meant to address the setup of a KBox PROdigy along with the BLACK khub with the KHub logo on it. This guide is NOT applicable to the OLDER silver KHubs.
1. Connect the KBox to the coax, and power up; 2. Load the UNZIPPED bin 2.01, (or later as they are released), onto your USB; 3. Insert the USB into the port; 4. When the explorer screen appears use the remote arrow buttons to highlight the bin; 5. Press OK 6. When the bin is done loading the KBox will reboot itself; 7. Setup and scan your satellites in the menu installation dish settings menu; 8. Go to menu installation options and change Stand alone to network; 9. Set ALL AU in the same screen to OFF. 10. Plug the ethernet cable into the port on the khub; 11. Plug the khub DIRECTLY into the KBox serial port, (NO cables needed); 12. Load the UNZIPPED khub.rom file, onto your USB; 13. Insert the USB into the KBox, highlight the KHUB file on the screen; 14. Push OK; 15. When the file has loaded remove the USB from KBox; 16. Using the switch on the rear of the KBOX, reboot the KBox.
Tune to an ACTIVE NAG 3 channel, (CNN 200), is a safe one. Then wait a couple of minutes and tv should begin to play
I did it by the USB port, and in the DHCP it's saying it's connected. I put the 1.76 then 2.01 then the khub.rom, it's the grey KHUB. I scanned and all the channels are here, the epg is here the description is here... But no image or sound... except the DN guy on 125. :-)
I disconnected my modem, router... The khub came without a power adapter, I tried on with the 5v recommended but I lost the channels number on my screen, so I plug it without the power adapter... No luck yet still stuck on Processing... Please wait... I plug it to the DSL modem directely... No luck also...
Hi Guys again... I found it, I forget to change for the Network instead of the Standalone... in the Option menu... Mode... It's always the small things... Thanks again...
Here are the instructions