Bronze Member Username: JinnspeedPost Number: 32 Registered: Jun-06 | I am new to using atmega. I am using Phoenix V 2.5.9 and it is not detecting the card. Following are important points: Card do not have jumper. Not req for phoenix loader. i am using serial port pin 3 to program atmega 18 crystal 128. I have the atmega programmer but do not know which pin will be used for programimg. I have 10pin atmega ans 3 pin atmega. For 10 pin i place all the pins into the programmer because it also has 10 femail ends. For 3 pin i use the first pin close to edge, the other two pins are without jumper, but jumper not necessary for phoenix loader Please let me know what i am doing wrong. Thanks |
Silver Member Username: Sam_patelPost Number: 101 Registered: Jun-06 | go to the wwww.dishgods.tv they will help you ok |