I just converted an old pansat 2500a to PUFF 290, and get scrambled channel. Are they down? I have a Viewsat and have had this old pansat for a while and decided to fix it for use in my garage/ card room.Thanks
Go again through th efull process. 1. Revert to 2500 using Chancy's special loader and b60 boot 2. Install the 294T BIN. 3. Properly install PUFF BOOt/BIN 253 by Chancy or Fwank7 4. Onstall latest PUFF BIN 5. Doo user setup 6. Do antenna setup for one sat only 7. Do scan of that sat. 8. Do other antenna setups and scans. FLU/2500 Conversion to 2700 workalike. Full kits for Latest conversion BINs and other files - also for Revert to 2500
[link removed] Download and unzip into separate directory. PLEASE DO NOT ATTEMPT WITHOUT READING INSTRUCTIONS.
I tried everything and then disconnected the satellite wire from the switch for a minute and then reconnected. Got the signal after about 30 seconds or so and i'm back..I was using 288 file though as part of testing everything and it doesn't seem to be causing any problems so i have kept 288 for now
