I am only getting 1/4 of the internationals channels that I used to get and it said "no signal" I have a Pan*at 2500 with PUFF, since there's no Anik F3 in my sat list I am using 121 to scan internationals and starting today I am not getting most of the Chinese channels, I even tried doing TP scan and most of the ones I am missing still won't come up, any idea? this happened after I loaded black tyger's 276 puff
I am using 121 to get 118.7(it's pointing at 119) with my 2500(converted to puff) it was working fine until yesterday, I do have a 33" with cb2008, after the black tyger 276 bin I lost lots of channels. any ideas nalin?
Nalin, thanks for the help. you are right, all my verticals don't come in for anik3, I've tried all the new puff bins in your folder(ALL_276b_PUFF) and they didn't do anything. I am still getting only a hand full of channels only, anyway how can I "restore" my international channels? thanks again
Ok with my luck, I guess it's not my day today. tried every single bin out there and still don't get my internationals back. even with factory reset and reload PUFF all over again.any clues, Nalin?
With receiver fully on and using BL updater 1.4, install CS or JVVH 253 640K PUFF boot bin. Let it reboot and go to ON. Then attempt to install the latest PUFF BIN with receiver just turned on and starting to show P-U.... If unsuccessful, use the "Revert to 2500" section to revert to b60, then add 294T and then go on to PUFF conversion and BIN. The receivers are very tolerant of repeated assault.
NALIN I NEED HELP!!!! I have a Pansat 2700 with puff. I have echo 3 61.5 only. I am not getting all channels.. do i need a different bin or anything else. I scanned many times and still didnt work
Nalin, TP 11715 does not come in along with all the other vertical TPs. I am ONLY getting horizontal TPs. and I am scanning with 10750, but I get more 119 channels than 118, funny heh? maybe I should switch back to b75? please advise, thanks
A.W. Try Revert to 2500 and then b75. If you still are not able to scan using 10750 and first TP 11715, there is something wrong with the LNB. Note that some of th ePUFF BINs use diseqC 1.0 #1 and 1.1 #1 etc, so try both 1.0 and 1.1