I have a good pansat box configured and works well.
Now I bought another box for my colleague.
Now disconnect my good pansat box and hook up the new pansat.
Now the New pansat has no LEVEL and Quality. I am having a hard time trying to get atleast one satellite working . example - Echo 7 I tried to make it work - but it does not get any Level and Quality.
Once I re-coonect my good pansat evertying works well.
Hadley..now write down the Antenna Setup from the working box than enter them in to the done working..
go to Menu..Installation..Antenna Setup..(Satellite)..write dowm LND TYPE..DISEQC PORT #..ECT... After that do a blind scan if you haven't scan it yet..
Are us setting up your buds receiver at YOUR house?...if so, it should work if all is EXACT same in both receiver settings...and always do a REBOOT ..and tell us exactly what is wrong or message U receive..
if not your house, he may have different settings than U, cause he may have differnt LNB's, switch and ports configured at HIS house..U need to be consistent, detailed etc...all houses and configs are NOT the same!
also is the b80 boot in buds receiver?...when was last time it worked?...etc...whats it say in system info thru menu?
Just behind the SD card slot - there is only one capacitor - It does not look bulging or burnt.
Behind the Menu buttons there about 3 to 4 BLUE colored capacitors that don't look like brunt or bulged. They are in general a little fatter compared the one I mentioned before.
If you have any pictures or documentation on how to they look like that would be great.
Hadley There are two (2) sets of Factory Files for Pansat 3500S. 3500S/SD (b-70) and 3500S/SD (b-80) You will need to load the right Factory Bins on both Receivers.
the best advice in your spot is simple pansat 3500s can send the file from one to next including settings. or you can just write down settings for working pansat then put on non working
