What could be the reason of losing channels after 5/10 minutes on Pansat3500. It happens only with Channels on Vertical TPs on my CB2008A LNB with 118&119 sats. After turning on the receiver I can see some level of quality and can see good picture. After 5/10 minutes, I see the quality jumps to 99% and looses the channel picture (scrambled)
i know free stuff mine doing the same thing on 118.8/119 lnb also but plymouth is right its most likely the switch cause i have 2 diseq withces and 2 receivers 1 receiver works fine.
mine works for like anywhere from 5 min to half the day on a channel on 118.8/119 vertical also then all of a sudden the channel will switch to the hallmark channel which is on 110 what do you think that is?
yea when the quality is at 70% its on the channel i want but when the quality jumps to 95% it turns in the hallmark channel or it will say bad or scambled channel or no signal?
Thank Guys...I will try to put this LNB on different port on the switch and see how it works when I go home. Little confusing as all other LNBs on other 3 ports are working good with good quality quality jump is not much...stays between 0-5%...
what do you mean by "If you loose voltage on LNB only horizontal channel go work"...does that mean my LNB is gone BAD? - seems to be that this issue started recently.
Nope...this hasn't started yesterday...was there previously...
As I remember, previously it used to show the channel even when quality jumped and stayed at 99%, now it doesn't show the picture and says scrambled when quality is 99% and that too only on these two sats (LNB).
Yesterday, I put the line directly from LNB to the receiver and it didn't work...so I was wondering it is my LNB that's gone bad. Or is it my receviver? - I doubt it because Vertical's from other SATs are good!
Its possible your receiver cant give enough power to LNB, with a true splitter for dish, in free outlet, with voltage tester on volt DC mode take voltage for see if it good. On vertical you need to have minimum 15.5 volts, i
I will try to do factory reset and try it when I go home.
Question is if my receiver can't give enough power, then why verical's on other LNB's are working great. I tried to get vericals from this LNB working with or without switch and had same result...have 99% quality and no picture! Good picture on vericals from other LNB's (110, BEV Sats)