No signal SV-4000

 

New member
Username: Siena

Post Number: 1
Registered: Feb-08
My SV-4000 gives me no signal after installing new bin file. It works for 2 to 3 hrs then when u shut down the receiver and turn it on again it says No signal.
I have two dish 61.5 and 119, switch settings, and switch already checked, no error there.Already tried hard boot many times,reload factory bin 3 times but with no luck,pls help
 

Gold Member
Username: Kirankumar

Kenya

Post Number: 1771
Registered: Oct-07
post your settings
 

New member
Username: Siena

Post Number: 2
Registered: Feb-08
Thanks African,
Here is the settings:
STB__SV-4000______________ Dish Type__ECHOSTAR3(61.5) & ECHOSTAR7(119)_______________

LNB Type__SIGLE_____________ Switch used ?SONICVIEW(CAME W RECEIVER)___________

Your Antenna Settings by Sat #
Sat_61.5______________ Sat___119_____________

LNB Power___ON_____ LNB Power___ON_______
Lnb Type__SINGLE_________ Lnb Type_SINGLE__________
Lnb Freq._11250__________ Lnb Freq.___11250________ default OK
22khz___OFF__________ 22khz______OFF_______ only if used
TP Freq._12224/V/21500/AUTO_____TP Freq.12355/H/20000/AUTO_________ default OK
Search Opt.___All___ Search Opt.____All__ default OK
Diseqc__4___________ Diseqc______1________ only if used
Motor___OFF________ Motor____OFF_______
Legacy SW__OFF________ Legacy SW_______OFF____ only if used

Which Loader are you using:__V0201________________________
Which bin is on the receiver:__2.17( THE LATEST ONE)________________________
What the specific problem is:_IT SHOWING NO SIGNAL,i CHECKED ALL WIRES,ITWAS WORKING FINE UP UNTILL EVENING THANIT LOST SIGNAL,REBOOT DID NOT WORK.

Please let me know if you need any additional info.
Thanks
 

New member
Username: Siena

Post Number: 3
Registered: Feb-08
anybody any help
PLEASE
 

Gold Member
Username: Kirankumar

Kenya

Post Number: 1797
Registered: Oct-07
Ray,
are you loosing signal on both satellites or just one
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us