Unable to scan channels after installing the board. When I unhook the board cables, I can scan the Satellites. It looks like there is only one way the cables can be attached. Suggestions please.
82 - All 32 TP's entered & checked (SV inbuilt list only has 24) 91 - All 32 TP's entered & checked 110 - All 32 TP's entered plus the required 4 extra turbo 8 TP dupes (total 36 TP's) 119 - Corrected order of the 21 TP's 118.7 - All TP's corrected 129w - All TP's corrected
Guide to Install 8PSK Adapter/Module - VS-9000/SV-8000 Guide for how to install 8psk adapter and the 8psk module to the Viewsat 8000HD and the Sonicview 8000HD.
C&P
1) Turn OFF the receiver and unplug the power from the outlet 2) Unscrew 5 screw (2 on each side, and 1 in the back) to remove the case cover 3) Remove the module bracket (after the bracket been removed) 4) Remove the sticker in the rear 3) Connect 2 cables to the sub-board 4) Connect the sub-board to the module . Please be careful that Parts mounted surface should be up. 5) Connect LNB Power cable from the power supply board to the sub-board connector. 6) Connect the cable with the smaller connector from the sub-board to the connector of PCB Please make sure the red cable should be in #1 pin. 7) Connect the cable with the smaller connector from the sub-board to the connector of PCB Please make sure the red cable should be in #1 pin. 8) Fit the module thru the hole(reserved for the UHF remote antenna)in the rear of the receiver tight it up using nut & washer 9) Connect a loop thru cable connecting the IF Output and the module input 10) Finishing job