i have cs7000.1 dish 61.5 and 2nd dish 119 & 110. all with single lnb.using a c00sat switch.al was well until 2 weks ago,but now the box detects only one bird,whichever is in port 1,changed out the switch but same problem.can anyone please help?
did you not get an answer from dantetn did you try the new switch you were waitting for i no my name is not nalin but i think dantern is right even new switch can be bad
Bruce,changed switch no good Nalin,all was fine until 2 weeks ago 110 and 119 on dish 500 and 61.5 on smaller dish all have single lnbs and 3 cables coming to switch.do u think it is time to install a dp34 switch?or what is the solution here?
Are there three LNBs or two?...and LNB or LNBs type You were going to change a switch. Have you changed the switch or not? Are you aware that there are different types of switches? Are you aware that some switches revert to Port 1 when they get zapped for any reason? Are you aware that the most common reason for switches burning out is connecting/disconnecting with receiver on? Before anybody can give serious advice, a lot of details are needed.
I have 2 Viewsat Ultra receivers. I have two different switches, but I'm only receiving PPV on one of the receiver. Also, if i have the satellite on 121 i can't view 110 on the second receiver at the same time. Any ideas??
Nalin i changed the switch (c00lsat switch)this time i can get 2 birds.third still missing.i always switch box off and unplug from wall when movig cables.you are right switch keeps reverting to port 1.lnbs are all single.came with dn installation.there must be better switches available.please advice
Nalin there are 3 single lnbs 2 on one dish and 1 on the second.as far as the make goes i dont know where to look for it.when the system was initially set up it was showing as single lnb
You should try a simple switch change - DisEqc 4 to 1. If you do go for DP34 switch, it may give more headaches, because you will need to power it at output port 1.