I could use some professional advise. I have 3500sd loaded the new bin file and get everything , however pictures freezes and then cuts off and indicates scrambled/bad channel , then a couple minutes later comes back on. Do I have a bad bin file or is ther something that I can do.
Well... Try to reload the bin, but I think it is a problem with the file... If it was working well before, and now is not, then is the file... Its coincidence that both of you have the same problems...
Hmmm should I try to dl it again from the same place or a different site? Also my guide is an hour behind and my tp freq in antenna settings. keeps changing and wont let me save them. Could that be the bin too?
Which one did you have on the box? I will recommend that you do a factory reset before installing the bin again... It's not normal that the box do that... Here, download this factory reset to your receiver and then try to load the bin again:
After you have installed the factory reset using loader 27.02, then re-install the old bin that you had before the reset (problematic bin). If it continues to have the same problems, then try this bin: [link removed]
Check that it works with the loader and receiver... Good Luck..
Satman if you do this can you just update me on it? Let me know if it worked? I wont get a chance to do it tonight or in the moring so.... Id reallly appreciate it. TY
Hey... If the 35.01 loader works for you, then use it... Yes, download the factory bin from anywhere you like... Then reload the bin that you already have to the box... see if it works... If not, try the newest bin, I put some links avobe, but you can go anywhere you like to get the newest...
Rtap where can I get the factory reset from though? future fta says its upgrading and it gives the newest bins on that page but you cant get any further into their site. I have the 339 bin from them. Tomhiro gave a site for fact.reset but it file doesnt work.
ok i loaded the factory bin and 339 and right now Im doing the blind scan thing. RTAP ,you asked about signal and quality ,I'll let you know when Im done here. But last night I had to change the TP freq. and it wouldnt let me save it and it kept changing. So I had no signal for echo 7,but 8.10 was ok.