would it be possible to load the new file on FLU converted to 2700 and then do a STB to STB for 5 other FLUs to save time. Instead of doing the setup again and again (Connecting all cables, Sat installation/setup,blind scan, etc) Will it retain the exact settings on all FLUs, Is it possible? Are there any instructions?
A) Connect the Master Receiver to the slave Receiver using a RES-232 Female to Female Nul modem Cable.
B) Select the s/w transfer mode using the volume keys
C) In the Code Mode, you are transferring the ""main" s/w from the STB (Master) receiver to the STB (Slave) receiver. To start the transfer, you must press the "Channel Up" key on the Front panel of STB (Master), not STB (Slave).
D) In the Data Mode, you are transferring the "main" s/w from the STB (Master) receiver to the STB (Slave) receiver. To start the transfer, you must press the "Channel Up" key on the Front panel of STB (Master).
E) Press the Exit key to cancel the transfer. After transferring the Code file.you should turn OFF, then ON the STB (Slave) receiver.
