My ppv and p0rn arent working and i was told that i have to upload a new bin to get 0106. Is this true and where can i get a loader and the bin to load it onto my 2700 clone?
I too have this problem. I still get all but PPV and P0rn. I don't to ruin this so how do I know what bin I am running and whether to change it or not?
KmW: Clone Pansat 2700: Use only clone BINs Tivo or Vortex. Use clone 27.02 loader.
Genuine Pansat 2700, use genuine BL BIN with 27.02 loader or the clone BINs above.
Converted Pansat 2700. These are receivers converted from Pansat 2500A and Fortec Ultra to work with modified Pansat 2700 BINs. They use only special conversions BINs by jvvh, UKR, Leafs, or Chancy.
The current version for all of the above is version 222, but each has its own detailed name to indicate which type of BIN it is..
BL updater 1.4 is THE recommended loader for FLU converted to a 2700. If loading the Chancy BIN, you may use Chancy's loader for the conversion files.
Your posts in this thread indicate some confusion between the 2700 clone and the converted receiver. You should clarify it to yourself and be more precise in future so you don't get into problems of wrong BINs.
ok....i have a FLU that was converted to a 2500 when i got it and a while back i converted it to a 2700 and then i had to leave town b4 i could put the new bin on and i just got back.....b4 i left i tried to load jvvh 218 with the FLU loader but it wouldnt work.....is 218 still working good or should i get a diff one? Thanx for the help
CS_221Tv2_lightning works very well with autoroll off. jvvh_Leafs_221 was reported working well. Both these have the 222 version out. With autoroll off the CS_222T still has a few glitches. I do not know about the status of the Leafs_222 version.
Dont know what is going on......loaded 221 lightning and went to scan sats again and i am getting nothing on 110 but i did when i just had the conversion bin on it.
CS_221Tv2 or CS_222T Bins. Preferrably load jvvh_208_1 first. Load the selected BIN. Connect. Turn on and press OK for English. Do default settings. Do user setup and make sure you have correct date and time and time zone. Make sure autoroll is on Turn off and on at the back. Do Antenna setupand connect DisEqC switch ports to known connections and Sats. Do power Scan of each sat. The picture comes in usually by the time one sat is fully scanned. Make sure there is picture. Turn autoroll off Switch off and on again. Scan missing TPs using TP scans or adding TPs. If channels are missing you may find them by doing alphabetic sort and looking under TV nnn, where nnn is the channel number missing.
i sorted the channels by tp to see which ones were missing on 119 and i noticed that the tp frequency on the tv was different than the ones on lyngsat.