Bronze Member Username: Patrick1966LONG BEACH, CA United States Post Number: 14 Registered: Feb-06 | Re:Pansat2700A setup on two TV's -------------------------------------------------------------------------------- Hello. I have two Pansat2700A's. I have one connected to a 46" television in the family room and one connect to my 26" televsion in my room. When i go to change the channel on my receiver in my room the other receiver loses it's signal and i fix it by rebooting it from the back. It is such a hassle. I have 3 dishes each with a dual LNB with one cable going to a disque switch and another cable going to a separate disque switch. I have diffrent lines going to each box. I have also tried to set the 22khz seting to on on one receiver and off with the other receiver, but still no luck. Can anyone give me any suggestions? |
Silver Member Username: RtapFL Post Number: 561 Registered: Jan-07 | try replacing your switches.they are known for given problems. |
New member Username: Malkusth4Penuelas, Puerto rico USA Post Number: 3 Registered: Oct-07 | I have a pansat 3500SD, but need help to program it Followed the instrutions.... I am not able to program it. Please help me to do THANKS PLUIS19@MSN.COM PUERTO RICO |
Silver Member Username: LroyPost Number: 282 Registered: Aug-06 | Re Pansat2700 problem. First check with your cable ends and ensure that they are clean and properly fitted to the cable, also make sure the cables are tighten to the LNB, switch and the receiver. You could also have a switch problem as well. |