It didn't work either. It is only scanning two channels.
I was getting all channels this morning but some english channels were not showing good quality. I deleted all the channels and then ran blind scan and now I am screwed.
gonxggo, blind scan Echo 3 (61.5) after setting the Diseqc switch to #3. Blind scan even if you don't see any signal strength when you set it to Diseqc #3.
I'm guessing blind here because you don't provide a lot of relevant information but here goes:
The English channels are on Echo 7 and Echo 8. If you have a dish pointed to those sats, and the cable goes through the same switch, Blind scan Echo 7 on Diseqc #1 and Echo 8 on Diseqc #2.
do a facotry set do a sat scan and make suere ur switch configuration is correct, like Abby said Diseqc switch to #3.try that then hit the receiveer off from the back the turn it on after a minute and wala ur done