I have done search and did a lot of reading before I decided to start this thread. here is my setup One Dish 500 with Dishpro dual LNB receiving 110 One Dish 300 (legacy??) with single LNB receiving 61.5 Both connected to Disecq 4x1 switch 110 in LNB1 and 61.5 in LNB2 Pansat 2500a with 293 bin. Everything was fine until I tried to download channel list. I don't know where did I go wrong? I saved channel list in gtool format, opened it in gtools, chnaged STB settings to STB2, put the correct switch number for each bird and converted 110 to dishpro and downloaded to STB. Now I can still get 110 but there is absolutely no quality for 61.5 Then I tried to connect 61.5 directly to receiver and loaded channel list only for 61.5 and it works that way. But When I tried to use both birds with a switch I get zero quality for 61.5. Just the reminder that both birds were working fine with the switch before channel list download. So it can't be the cables or the switch. I have already done factory reset and reloaded 293 bin file but same issue even with no channel list. If someone has experienced the identical situation please enlighten me what is going on? Reply With Quote