Check your settings. Likely you just need to set the switch settings, however you have them. If you have a diseqc connecting 3 LNBs, turn diseqc ON and set committed for ports they are connected to. But you may have a different switch? Explain your setup (switches used, LNB types) and your problem can be better answered.
i have a dp 34 switch, and i set it to the right port,but when i set the 110 singal ,untop i got 119 singal.bit no 61.5 singal also , the only one is 119 that works good.
Sometimes you see different boxes with different calibrated levels. 80% is fine.
Not sure what you mean "but only by box"?
Also above you said " i did but the 110 single " Does that mean you have the LNB type set to "single" for 110? If so, set it for OSC-DP (we hope it's a dishpro if you're using dp34 switch!).
Is this a DP twin or quad LNB you're using for 119/110? You have to plug 2 wires, one for each 119 and 110, into the switch ports 1 and 2.
Well something is screwed up. In the setup for 110: it is diseqc 1.0 (not port 1) and then COMMITTED 2. Are you able to run the cable from the 110 LNB straight to the box, bypass the switch?