I am just adding VS Ultra to an existing setup. Presently Superdish and Dish 500 are feeding Sub DN receiver thru SW44. When I hooked up VS ultra, it kept displaying searching signal message. I could see signal strength at 100% and quality at 80%. Following is the current Antenna Setting: 119 LNB Power 18v LNB type Universal LNB freq 11250 22khz off DiSEqC off SW off
110 LNB Power 18v LNB type Universal LNB freq 11250 22khz off DiSEqC off SW off
61.5 LNB Power 18v LNB type Universal LNB freq 11250 22khz off DiSEqC off SW off
I am not sure what needs to be adjusted. Thanks for ur help.
Step-1 119 LNB Power 18v LNB type (MATCH YOUR LNB TYPE) <<<<< LNB freq 11250 22khz off DiSEqC =PORT-1 <<<<< SW =SW44 <<<<< Do Chan Scan sat (F1)
Step-2 110 LNB Power 18v LNB type (MATCH YOUR LNB TYPE) <<<<< LNB freq 11250 22khz off DiSEqC =PORT-2 <<<<< SW =SW44 <<<<< Do Chan Scan Sat (F1)
Step-3 61.5 LNB Power 18v LNB type (MATCH YOUR LNB TYPE) <<<<< LNB freq 11250 22khz off DiSEqC =PORT-3 <<<<< SW=SW44 <<<<< Do Chan Scan Sat (F1)
If you don't know what LNB type you can try standard but it is better to match correct kind receiver 1 and 2 turn off 0/22khz You may have to use 0/22k on receiver 3 and 4 To allow polarity switching to all 4 receivers Sorry I don't have manuals for this
Thanks guys for answering. Superdish has DPP and Dish 500 has DP LNBFs. Now since there is no option available in the menu, how do I select SW44 here? Also, even though I am not using DiSEqC switch, you have suggested to select ports 1, 2, & 3. How does that work? Are these ports corresponding to the SW44 ports in the absence of DiSEqC?
