Please help on the setting for my ultra.

 

Silver Member
Username: Micklee11801

Post Number: 107
Registered: Feb-06
Hi Guys,
I just got myself a new ultra and I am using dish 500 with 2 dish pro dual LNB to diseqc switch. I have a question on the setup, when I scan in the channel on 110 and 119. I only get 112 channels on 110 and 154 channels on 119. What is the problem? Would it be my setting on the menu?
Here is my setting:

119
lnb power-on
lnb type-standard
lnb freq-11250
22khz-off
tp freq-12239
search option-all
diseqc 1.0- port 1
motor-off
legacy sw-none

110
lnb power-on
lnb type-standard
lnb freq-11250
22khz-off
tp freq-12224
search option-all
diseqc 1.0- port 2
motor-off
legacy sw-none
please help me with what I did wrong. Thanks!
I have been looking on the sticky but not able to find the setup on it.Upload
 

Silver Member
Username: Micklee11801

Post Number: 108
Registered: Feb-06
can someone help please?
 

New member
Username: Mrskullz1

Post Number: 9
Registered: Feb-07
are u getting any repeats? also for lnb type put in dishpro not standard
 

Bronze Member
Username: Hemanjoyman

Post Number: 31
Registered: Jul-04
It does not have a setting that specifically says "dishpro," you have to set it to "OCS-DP."

And scan each sat. one by one, don't do them both at the same time, and make sure you don't do a "Blind Scan" you have to select each one one by one in the "Auto Scan" by putting a check mark next to the sat you are scanning. Make sure when you are scanning 119 the power to 110 is off and port set to none. When you scan 110 make sure the power to 119 is off and port set to none. Then go back and set it to the settings you posted above. Then just exit and save. You should be good after that.
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us