Help with Switch SW64, 3 Dish Receivers and 1 Viewsat, thanks.

 

New member
Username: Hakunamatataa

Post Number: 1
Registered: Feb-07
Here is my system and I do have to say that I am new to this. Thanks
for your patience in reading this fully.

I have two satellite dishes that come in a SW64 (4 inputs and 4
outputs). I currently have 3 receivers, all Dish Network equipment. I just
bought a viewsat receiver. I get a bunch of local US channels and some
international channels on my dish system. Check switch will yield signals
from the following satellites:

119, 110 and 61.5 (odd even odd even etc...)

Signal strength is good all around at 95+.

To try viewsat I replaced one of my dish receivers with viewsat and
went through some installation (LNB freq 11250 etc...legacy switch 64
etc.).

I can only get the national channels but none from the international
satellite transponders?

Can you please help, thank you in advance. Please email me directly at
hakunamatataa@yahoo.com if you need more information.

Regards,
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us