Need Sat file to program Viewsat Platinum 2000

 

New member
Username: Shawna1970

Post Number: 1
Registered: Dec-06

Hi,I am new here so if i post in the wrong place, that's why. I have the new autoroll file but need the Sat file for Viewsat Platinum 2000. Can someone please help me out? It would be greatly appreciated. Thank-you in advance.
 

Bronze Member
Username: Psychomofo

Post Number: 83
Registered: Nov-06
Hi, go to Cyberdss.com, they have everything there.
 

Gold Member
Username: Lklives

Post Number: 6138
Registered: Jan-06
All U need to do is a factory reset and a scan...or make your own sat file..

Before a scan, go to edit satellite settings and delete all TPs except for TP1 for each sat which is 12224 for 110, 91, and 82 and 12239 for 119. Make sure the settings for that single TP are correct and then perform a regular scan. In the process, the receiver will automatically locate all TPs whether they cover your geographic area or not. I've done it this way every single time and my scans are flawless no matter which PGM file I'm using."


This technique works perfectly every time. The problems reported here are not related to this procedure. I have done this procedure over and over again and it always comes up perfectly.

Delete all TP's except the following corresponding spot beams then do a channel scan within the same installation screen by pressing okay:

110 - Start scan at 12224 deleting all others
119 - Start scan at 12239 deleting all others
91 - Start scan at 12224 deleting all others
82 - Start scan at 12224 deleting all others
61.5 - Start scan at 12297 deleting all others

F3 is the delete button.
Just wanted to add that when I scan, I turn the power off to all other LNB's except the one I am scanning. Make sure you turn them all back on once complete! C/P from dsscommunity site..
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us