Hi, I have a Pansat 2500 (not a clone) and have the 281 bin with autoroll off. When I do a blindscan, it says "0 transponders found". SO i reset the receiver back to facotry settings and installed the new bin 284. I uploaded the channel list to my receiver and tried a blindscan again and same problem. Is there anythign else that needs to be done?
You need to check first if you are getting any signal level from the LNB....do you have signal level and quality???
Check your hardware first, check if the dish is still properly aligned, after that check all the cables from the LNB to the switch, check the switch itself by changing to another input and also check the configuration of the sat's on the installation menu, what normally happens is that if you did a factory settings you will loose all of the configurations on the installation menu....
