Hi I have Pansat 3000, prehaps a clone, was missing some channels, I did a factory reset but after that whatever I do I can't get any channels on 119(echo 7Ku) like ppv or anything else...Help...Pls...!!! I only get all channels on 61.5(echo 3Ku), I tried satellite scan, blind scan echo 7Ku(119), it gave me same channels as on 61.5(3ku), no ppv..
PLEASE NOTE: This has already been done, these instructions are for when you have to update the receiver in the future. Copy and Paste from http://www.ftafile.org/
PANSAT 2500A - Set Up
Turn on at back Hit Menu on the remote
Go to parental control and enter option
4. Choose second pin option and enter 0000
5. Make sure KeyCode Function is on
6. Choose Nagravision in the cas menu
In the Provider ID, using the volume keys hit the right button until you find the Provider you want. E.G. Dish Network Now click OK, to store, OK will flash until done storing Hit EXIT three times Scroll up to Installation, press OK Scroll to Antenna Setup, press OK Using the volume arrow keys, remove the checkboxes beside all the satellites your not aiming dishes at. When your done there should only be checkmarks besides the satellites your receiving. EG. ECHO 110 & ECHO119 You should have strong level signal and quality signal if your dishes are aimed correctly Hit EXIT once Scroll down to Blind Scan and hit OK Make sure the Satellite is the one you chose, scroll down to Scan, make sure it says ALL, hit OK It will now begin to scan the satellite for all the channels it can download.