no indian channels on vs extreme with new bin. i do get their name on echo 6,8 @110 but when i go to channel it just say "searching signal" i was getting them with old bin. any help please? will be appreciated
ok bella when u change ur channel from 110 to 61.5 it says searching signal.. do this change the channels from 110 to 61.5 and when it says searching signals turn off ur receiver from the remote control and then turn it back onn from the remote control walllaaaaaaaaa there is ur picture on 61.5.... to avoid this problem for ever check ur antenna settings diseq 1 to 4 or may be ur diseq is bad... change ur diseq let me no whats happening ok ...
Rakesh, I have DN Account, with TVASIA & ZTV, but when i look for ZCINE its still in red. And when i hook up the pensat upload the 273bin, i can get zcine and nothing else. So i don't think ZCine is a Free Preview
army45: if u go to Zcine and llok for its CAS you would see free, but for all other chanels, you would see "Nagravision". Zcine is free preview. When you say you have a DN account do you mean you are subscribing to DN? If yes, then it's a different story alltogether.
If you have Viewsat (or Sonivview SV 1000) with the latest BIN 2 days old, you should see nearly all the Indian channels on Echo 3 (61.5W). I beleive Captiveworks BIN is also out in the last 24 hours. For most other cardless receivers, there is not much on Echo 3. However, the ZCIne channel has been left wide open by DN and you should be able to see it. If not, then you really have a very old BIN. Your good BIN for most other receivers is dated around 8-18th June. The valid Keys are about 2 weeks old now. Fro Viewsat: If you are seeing ZCine on Echo 3 and not seeing other Indian channels, you have to make sure that you have the new BIN that is 1-2 days old now, and you have autoroll on. Switching the receiver manually off and on with the switch at the back sometimes helps. Rescanning using Blind scan (instead of Scan All) sometimes works, as this will get all the channels on Echo 3. For other receivers, the presence of Zcine means that you have the current valid BIN and that you ar pointing at the satellite. You will need to wait for a new BIN.
hey i need help here...i have pansat but m hearing it dead so m deciding to buy a new box..which one should i Sonicview or Viewsat?..i want a cardless one..and does these 2 have the key thingy too..if it goes away i put the new keys just like with the pansat one..cuz i dun want the card one...Nalin can u help me with this??