Gr8 Quote: Your Question: Hey guys, I have superdish 121 and I am able to recieve signal from 119 and 110 but not 121. I have 121 on disceq 1, 119 on 2 and 110 on 3. I tried alot to move the dish but no luck. do you think anything wrong i m doing. Now I am getting all channels from 110 and 119. But no 121. Please help. Thanks.
Answer from TDG
-------------------------------------------------------------------------------- Gr8, follow this exactly: How to get 121 with your superdish 121. 1. Under antenna setting, LNB type for 121 should be on "standard", compared to 110 and 119 which is set as Dish-pro. Assuming that you have the original LNB's. 2. 121 LNB frequency, should be set to "10750". It's linear type, compared to 110 and 119 which is circular. 3. Your basis for focusing is 119. So check your signal on 119. 4.HERE'S THE TRICK HOW TO GET THE 121. THIS WILL REQUIRE PATIENCE, OR YOU WILL NOT GET IT AT ALL (IF YOU HAVE NOT DONE THIS BEFORE). Assuming you now have signal on both 110 & 119, YOU WILL MARK YOUR 119's azimuth and elevation with a fine tip pencil, just in case you lost everything, and have to go back to scratch. Now check your signal on 121, which is probably ZERO. VERY, VERY SLOWLY, YOU WILL ADJUST YOUR DISH TOWARDS THE RIGHT (standing from behind the dish), 1 millimiter at a time, pause every five seconds, and you will notice that your 121's signal increases. Once reached the peak signal, fine tune the elevation, and tighten all screws when done. 110 and 119 will automatically fall in place, AND NO FURTHER, ADJUSTMENT NEEDED. You will NOT get as much as high signal (121), compared to 110 & 119, due to the nature of the dish, but more than strong enough to get ALL the 121 channels.