I have a superdish (119, 110, 121) . And when i hook up to my receiver, normal one which comes with dishnetwork i get the signal and everything is good. My signal strength is 102. But when i connect the Viewsat receiver, the signal strength and quality are in the 80 range.
But i was still able to do a blind scan and get the channels, but the problem is after 10 or 15 minutes of viewing, the satelite connection is lost and it says checking for satelite.
If i switch off and on the power on the back of the receiver, it is fine for a minute or two and again it does the same.
Anyway knows what is going on ? Any help is appreciated.
I have the guide for viewsat from the dss site. But they dont have the autoroll related info. Sorry to bother so many people... but if steps can be provided it will be great. I cant watch anything for more than 5 minutes.
yes do you need before stop autoroll reset factory settings, and before you cant get see any channels do you need stop autoroll, if you cant see channels your autoroll function its already enable, do you need, restore factory settings, set your box, date etc, and stop autoroll. enjoy
are you hooking your viewsat up and unhooking the regular reciever? the regular reciever needs to hooked up to power the dp34 switch because the viewsat doesnt have enough power to run the dp34 switch.the lose of signal is because the power to the switch and lnbs is turning off because of breaker in viewsat box