278 bin / knightrider lights

 

New member
Username: Keithh

Post Number: 1
Registered: Feb-05
just loaded 278 bin on 2 receivers and now all i get is knightrider lights ---- anyone know what to do next to either reset the units or allow me to reload another bin / thanks / kh
 

Gold Member
Username: Lklives

Post Number: 3683
Registered: Jan-06
there is NO legit 278 bin...its bogus...now U must do the nite rider fix ...flash/upload receivers with Pansat 2500 factory bin 222 or 224..
 

New member
Username: Keithh

Post Number: 2
Registered: Feb-05
thanks LK - I didn't see the RX resposnd when I first tried to load the 224 so I thought it was fried - did the full 224 load and it came back to channels when it reset. now waiting for the new fix / kh
 

Gold Member
Username: Lklives

Post Number: 3685
Registered: Jan-06
U have nite rider lights!...U need to load the original 222 or 224 bin back in..then upload the 277...uploading a bin is all TIMING!

BTW..the bins are in the Pansat 2500 topic area at www.dsscommunity.c*om...must register first FREE...and remove the * in link!

Post subject: Flash Failed..Night rider fix, .. and Loading bins..

--------------------------------------------------------------------------------

Flash failed is either a defective cable or SERIAL port; or use of the wrong cable or comport..
-------------------------------------------------------------------------------- -----
Here is how to recover from the "Night Rider" (flashing lights):

1. Try re-flashing the factory boot/flash again using the below directions. That gives you FTA ONLY. Follow the above procedure.

2. Then, when that works use the latest flash to get the scrambled channels.

3. Download a channel list and/or do a channel scan on each sat.

4. When flashing, be sure to wait not only until is says done. But you need to wait until it reboots and actually goes to a channel number.


--------------------------------------------------------------------------------

Here are a few tips if you are having difficulty flashing: loading a bin..

I would advise everyone to read a set up guide before flashing. But, since people have been having some problems, I have revised this to provide more detailed information. But this is not intended to be a substitute.

1. Make sure you use the proper serial cable for your receiver:
Most Fortec and Pansat use a straight through cable with DB9 females on both ends.
The Blackbird, Pansat 2700/3500 and some other receivers use null (crossover) cable, which crosses over pins 2 and 3.

2, With the power turned off, connect it to your computer and receiver using the serial connector. Use serial port #1 if you can.

3. If you do not have a working SERIAL port, you must install one or use a computer that has one. Usb ports do NOT usually work, except on rare ocassions with an adapter.

4. Use the appropriate loader.

5. Select the file. Make sure that it is the correct flash for your receiver.

6. Select the COM port your receiver is connected to. If you do not know, what it is try #1 first.

7. Enter the correct model name and number. Most Blackist updaters do Not require this.

8. Check off the correct function box. Your choices are boot, flash or channel list. To FLASH your receiver you would use FLASH. Most flashes do not require a separate boot; so do not load both separately.

9. Turn on the receiver power from the BACK switch.

10. As soon as you see the lights flash,very first light -- IMMEDIATELY press download. Timing is critical and many vary.

11. Wait until it COMPLETES and reboots.
 

Gold Member
Username: Evadelparaiso

Puerto Rico

Post Number: 1261
Registered: May-06
...
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us