I downloaded the new bin file for pansat 2700 the signal is strong ober 76% for satellite eco9/121 using a superdish. When I try to do a blond scan sometimes it freezes at 20%. I try again it stops at 35% and sometimes 46%,... Any one knows how to fix this ?
Failure to be able to do a scan usually means that you haven't got a good enough signal. Even though level is high, the quality could be low. Make sure you have at least 60% quality.
If quality isn't the problem then re-download the bin and recheck your antenna settings.
Assume you system is worked before Key&Bin change .
So I thnik you are missing few steps after upload a new BIN to your receiver .
Back to start from beginning :
1. Check your key , If key is not correct so do a correction. 2. Turn on your autoroll (because you did update a new one) 3. Do set up satellite and do scan (one by one)
Signal and quality is over 70% Autoroll is on Key is correct since I can get some channels The problem is when I do a blind scan for every sattelite seperate they do not finish. They freeze on 35% or so ! any other suggestions ?