Bronze Member Username: OnlyaliPost Number: 21 Registered: May-06 | hi guys if any one of u can help me please, ther problem is dat even if i have multi dish switch i cannot see, echo 3 and echo 7 programing , it only scans or show on sat channels at a time, i put switch 2 for echo 7 and changed the disq to 2 and echo 3 as disq 1, http://i5.tinypic.com/125t0no.jpg these are the dishes iam using upper for echo 3 and down one for echo 7 http://i5.tinypic.com/125s481.jpg This is the switch iam using and i have applied same setting from menu in antenna setup, http://i6.tinypic.com/125s5et.jpg This are the setting for Echo 3, and if same setting for echo 7 only disq is# 2 in echo 7, http://i5.tinypic.com/125s7br.jpg in above pic , it scans channels from echo 3 , instead of 7 , buh in da bottom it says echo 7, http://i5.tinypic.com/125s80o.jpg Above is da dish iam using for echo 3 http://i5.tinypic.com/125s8jd.jpg above is da dish for echo 7, The only solution so far i can find it tht i can c on sat programing at a time , not two any suggessions please, thx in advance |
Bronze Member Username: OnlyaliPost Number: 22 Registered: May-06 | anyone can help plz? |