Alright all you experts out there, here's my problem: On a pansat 3500S, I am able to see only 119. When I scan for 110 I get essentially the same channels as 119.
My setup was set up by a dish professional for the Dish reciever 301 as follows: One cable runs from a DishPro Twin LNBF (110 & 119) dish into a DP21 switch (Dish 1) . Another cable goes from a DishPro Dual LNBF (61.5) into the DP21 switch (Dish 2). Finally, a cable runs from the DP21 to the Pansat 3500S.
With 119 on DiSEqC 1, 110 on 3 and 61.5 on 2 Here are the results: A blind scan on 119 gives all the channels for 119, a blind scan on 110 gives the same channels as 119 and 61.5 gives all the channels on 61.5. So my problem is that I am not getting any 110 channels.
By the way, 61.5 only gets channels on DiSEqC 2 & 4. That's why the DiSEqC settings are what I mentioned above.
Also when I hook up the wire from the DP21 to the DN 301, it shows all channels on 110, 119 and 61.5