Scan problem

 

Anonymous
 
Have pansat2500 when I do a blind scan all tp come up, but channels and radio are 0 found.
please help.
 

Silver Member
Username: Lklives

Post Number: 266
Registered: Jan-06
sounds like bad disque switch or dish not aligned..or receiver not configured to the LNB's and disque switch...
 

sb3cb
Unregistered guest
Thanks LK will change switch and see if this solves problem. how should the LNB'S and switch be config.
using two dirtv dishes with sw21
 

Silver Member
Username: Lklives

Post Number: 268
Registered: Jan-06
Cannot use sw21 switch with FTA receivers..
 

J Roo
Unregistered guest
LK

I am using a sw21 with a dish 500 dish, and a c---sat 5000 . I have no problems with this switch.
 

Silver Member
Username: Lklives

Post Number: 272
Registered: Jan-06
U are very fortunate..
 

SB3CB
Unregistered guest
LK

Did away with sw21 switch. Ran cable from dish
to pansat 2500 did blind scan. Still have same problem 0 channels found.signal level 84.
 

Silver Member
Username: Lklives

Post Number: 317
Registered: Jan-06
U have some defective hardware,if U ran RG6 cables directly from LNB's to receiver and have NO channels after doing a scan..U should at least get the free FTA channels,if U don't have the latest bin uploaded,if not U have bad hardware....LNB's, cables, connections, receiver etc..

I know there is something VERY IMPORTANT that U are not telling us..this is a wild goose chase with the little info U provided..
 

Silver Member
Username: Lklives

Post Number: 318
Registered: Jan-06
also U must align dish towards the 110-119 if U want dishnet channels, have U done that?
 

SB3CB
Unregistered guest
Both dishes are aligned. sig 84 on 110,82 on 119
Have channels now on both sats.
Trying to scan and get channels that have changed
tp's.
after loading bin in dec.Scanning went fine no problem.

Tkanks for your responce.
 

Silver Member
Username: Lklives

Post Number: 320
Registered: Jan-06
what fixed your scanning problem?...what bin are U using now?
 

Silver Member
Username: Lklives

Post Number: 321
Registered: Jan-06
and what bin were U using that wouldn't allow scanning?
 

SB3CB
Unregistered guest
Sorry for confusion have not scan again since december. Have been tring to blind scan
to get channels that have changed transponders.
Not at reciver location now and can't remenber last bin file loaded.
 

SB3CB
Unregistered guest
bin 256
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us