got 3500s when on echo 110 & switch to bev 91 it's fine but when switching back I have to disconnect bev 91 cable on diseqc switch before signal on 110 comes on to watch tv. Anyone else have this problem.
Either bad disque config in your receiver or bad switch..
Beat_This
Unregistered guest
Posted on
I think it is most probably a bad switch, I used to face similar problems with three different switches. Get yourself a Spaun Multi Switch which costs US$50 online and it works flawlessly, I got one and no trouble. The second best one would be a Pansat switch which works not bad either. Also as LK suggested check your port config on the receiver for each Satellite.
Cameron Johnson
Unregistered guest
Posted on
double checked config & is correct have Pansat switch originaly now tried Digiwave. I now can switch satellite but signal goes from 0-72 on bev 91 & sometimes stays on 72 but no picture & if the picture does come on for certain channels it's on for about 1 second then freazes. THANKS for the help.
Anonymous
Posted on
Also using different LNB's for the different sats can cause this.
Did U recheck your receiver configuration disque setting AFTER changing switches....did U do a receiver reboot (BACK of receiver, power off,wait 2 min, power on,turn to good channel)...do U have a good BEV bin on like the 136...