Need help!
|
Anonymous | I downloaded a bin to a fortec ultra did a satellite scan but not all channels came through... Previously I set that receiver to a dish that had separate Lnb's and I was able to watch all channels. The new dish that Im trying to connect the receiver has different lnb(dish pro) Im not sure if this is the problem...If it is what do I need to do? |
|
New member Username: CowpungPost Number: 1 Registered: Nov-05 | I'm not for sure but I think DishPro has a built in DISEQC switch. If it does you will need to go in and set your satellite 110 to switch 1 and 119 to switch 2. Or the switch you wanted on. |
|
Bronze Member Username: As400Post Number: 72 Registered: Nov-05 | Dishpro "DP" has an internal switch. Run only 1 cable to your receiver. Remove any diseqc switch you had and program each bird with no diseqc. if you dishpro lnbf has two outputs, is a dual and you can connect two receivers if your dishpro lnbf has three outputs, the two on the left are for receivers and the separate connection is an input for a 3rd lnbf if your dishpro lnbf has four outputs, thats a quad DP and you can connect up to 4 receivers to it. Best of luck IBM |
|
Bronze Member Username: As400Post Number: 75 Registered: Nov-05 | Dishpro installation manual: (http://www.solidsignal.tv/dishnetwork/DISH_Pro-DISH_Pro_Plus_Installation_Guides/DISH_Pro_Quad_LNBF_Installation_Guide.pdf)  IBM |
Main Forums
Today's Posts- Home Audio Forum
- Home Video Forum
- Home Theater Forum
- Car Audio Forum
- Accessories Forum
- All Forum Topics