I have a superdish from dishnet and another dish for globecast(to get my Telestar5). Is there a way to use one FTA and receive channels from both dishes? How do I connect both to one FTA?
switching
Unregistered guest
Posted on
youll need a DiSEqC switch.run the coax from the reciever to the switch then to the dishes
Thanks_Switching;)
Unregistered guest
Posted on
Thanks! I have a DiSEqC switch. It came with the FTA and I hope it is good. So I will connect output from one of the dishes to LNB1 and the output from the other dish to LNB2, right? I will not use the LNB3 and LNB4 on the DiSEqC switch, right?
Learning_Still
Unregistered guest
Posted on
I did the above now I have 110 and T5 but missing 119 and 121. Remember, Dishnet had it set up that i get all 110, 119, 121 together...is that a problem?
Learning_Still
Unregistered guest
Posted on
I forgot to mention i have legit dishnet and T5 subscription on two different dishes and i am trying to get both using one pansat 2700.
LK-Really_Left?
Unregistered guest
Posted on
I guess LK left. Usually he answers all these questions.
ThiIl1951
Unregistered guest
Posted on
yes.....hes gone for good. he was used and abused. enough was enough.
Anonymous
Posted on
Still not a problem if you have 3 seperate lnb's for your 110 119 121, sounds like you may have a lnb with built in switch. If so get a lnb bracket that holds 3 sperate LNB (like DTV uses) and run them thru the diseqc switch using ports 1-4 setting your receiver up to each corresponding sat. 4 sats T5,110,119,121 and four positions on the switch, it's that simple.
babysteps
Unregistered guest
Posted on
Thanks anon! I will try it.
CRYING-TIME-AGAIN-U-ARE-GOING-TO-FU@K-OFF-AGAIN-
Unregistered guest
Posted on
-Thrill 1951, LK, Largo keys, Who cares he just a crybaby like most of u jirks..