|
New member Username: John_delaquioxHialeah, Florida Usa Post Number: 1 Registered: Dec-04 | I am trying to clone the Newton Series T300 Tower Loud Speaker coz I do not want to spend the 1,299$ for them even though i think they have the best all around design So I am having a Custom Box made for it by some guy at the flee market who does good work I want to use these components Kappa Series KAPPA42.5I 4" 2-way multielement loudspeaker pair for the highs with maybe the Reference Series REF6002SI 6-1/2" Two-way shallow mount as a bigger set of speakers Also For the two woofers Kappa Series KAPPA 100.3DVC 10" Dual-Voice-Coil Subwoofer as the first woofer Kappa Series KAPPA 120.3DVC 12" Dual-Voice-Coil Subwoofer as the secondary woofer I want to use in each speaker this amp Pioneer 150W x 2 Bridgeable MOSFET Amplifier with Tri-Mode Power Distribution GM-4000F all from http://www.infinitysystems.com/caraudio/products.aspx http://www.cambridgesoundworks.com/store/category.cgi?category=searchresults http://www.bestbuy.com/site/olspage.jsp?id=cat12085&type=page&sc=ALL&qs=pioneer+ amp&cp=1&sp=Relevance&mipp=25&uq=pioneer+amp&_requestid=221836 I was wondering if anyone could recomend a way to power the clones for use as a hometheater speaker system I read in another Thead about an AC to DC power supply converter but i am not sure how it could be set up If anyone can help you can email me at Less_than_john@hotmail.com I am also wroking on a computer mod where I mount a Jensen 200 watt XA2100 to the computer case but need to know if anyone can tell me how I can power the amp using the cumputers 450 watt power supply Thank You |