Kenwood VR 209 receiver

 

New member
Username: Dennis

Post Number: 1
Registered: Jun-04
After it's turned on , shuts off in 3-5 seconds and the standby light starts blinking. disconnected everything, tried again , same thing happened. Any ideas> Thanks
 

Silver Member
Username: Project6

Post Number: 631
Registered: Dec-03
try resetting.
Hold down the power button and then unplug the power cord. Hold it down again, then plug it back in.
did you use 4 ohm speakers? If you did,the amp is probably blown, the 209 is not good with 4 ohm speakers and will overload.
 

New member
Username: Dennis

Post Number: 2
Registered: Jun-04
Berny,

Thanks. Tried the reset didn't work. I had surround sound set up 2 paradigm titans, 2 atoms, subwoofer and center channel. system is about 6 years old. assuming the amp is blown, what would you recommend as repalcement receiver.
 

Silver Member
Username: Project6

Post Number: 637
Registered: Dec-03
What is your budget?
I'm still using a Kenwood KRF 9070D with Outlaw 7100 and Axiom speakers.
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us