|
New member Username: JamesdunnPost Number: 3 Registered: Sep-04 | I have 2 1000 watt DVC 4 Ohm speekers.I what them to get the most power frow my amp.My amp is bridgeable and it is 4 Ohm Stable bridged. How can i wire them to my amp to get the most power sent to them and it stell be SAFE for the Speekers and Amp. Thanks For Any help. |
|
idmax is da best Unregistered guest | i no u can get 2 ohm load but juz n case g2 rockfordfosgate.com and then go 2 the wiring wizard itll show u 2 make sure |
|
Bronze Member Username: NickkkCharlotte, NC US Post Number: 19 Registered: Aug-04 | if u run all the subs off one channel in a parallel conection ur lookin at a 1ohm load which would not work. if u wire the voice coils together in a series conection and the wire the subs in a parallel conection i think u end up with 4 ohms even. check the web site to be sure |
|
Silver Member Username: Joe718Brooklyn, NY Post Number: 120 Registered: May-04 | you have to use a series/parllell wiring herees a link to help you http://www.crutchfieldadvisor.com/ISEO-rgbtcspd/learningcenter/car/subwoofers_wi ring.html?subs=2&impedance=DVC4x2 |