Polk DB10 Specs....???

 

Bronze Member
Username: Caraudiofng

Houston, TX

Post Number: 58
Registered: Aug-04
Anyone know where I can find them? I've looked at polk's website and the farthest back it gives information on is the dx series and that's the ones that came out right after mine. Subs look itentical except the writing is in blue. They are rated at 300w rms 600w peak.

I'm pretty sure mine is rated at 300w RMS. It's in a sealed enclosure. Would it hurt if more power was ran to it?
 

New member
Username: Slap_johnson

Arizona

Post Number: 6
Registered: Aug-04
Driver Complement
Woofer 1 - 10" Diameter (25.40cm)
Dynamic Balance Polymer Composite dish cone

--------------------------------------------------------------------------------

Electrical
Overall Frequency Response 28-200
Nominal Impedance 4 ohms
Power Handling (continuous) 270 w
Power Handling (peak) 540 w
Efficiency 86 dB
Voice Coil Diameter: Driver 2" (5.08cm)

--------------------------------------------------------------------------------

Driver Mounting Depth
Top Mount 5-1/2" (13.97cm)
Bottom Mount 6-1/4" (15.88cm)
Cut-out
Driver Cut-out Diameter 9-1/16" (23.02cm)

--------------------------------------------------------------------------------

Theile/Small Parameters
Recommended Enclosure Sealed / Ported / Bandpass
Resonant Frequency 37 Hz
Qms 7.0
Qes 0.62
Qts 0.57
Vas 0.85 cu. ft. / 24.0 L
Sd 54.25 sq. in. / 350 sq. cm.
Xmax (linear) 0.3 inch / 7.5 mm
Xmax (mechanical) 1.0 inch / 25.4 mm
Le 1.85 mH

--------------------------------------------------------------------------------

 

Bronze Member
Username: Caraudiofng

Houston, TX

Post Number: 64
Registered: Aug-04
Sorry should have made myself more clear. The OLD Polk DB series....like from 5 years ago.....
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us