hi post the numbers/letters from below the main barcode something like 7700xxxxxxt123 or 8200xxxxtt123 or the security code like Q123 or T0U123 can be found in a small box then i can help you
Switch Radio On - Display Shows " 0000 " with the 1st digit flashing Rotate " Thumbwheel " For Correct Digit Press " " On The Stalk Control To Enter Rotate " Thumbwheel " For Correct Digit Press " " On The Stalk Control To Enter Rotate " Thumbwheel " For Correct Digit Press " " On The Stalk Control To Enter Rotate " Thumbwheel " For Correct Digit If the correct code number is now shown Press And Hold " " Until A Beep Is Heard
Hi, I have a problem with my radio, i thinks its locked as when i took the radio out of my car then put back in few days later, it would not work, my radio details are
Renault Radiosat 6010 7700 426 483 --- philips 22DC459/62E 9022 214 59622 PA4, 4*15W, RDS CD Changer Control FD 05 97 48 2011418 Prod No: FD 0597482011418 number stamped on the side is RN459FV2011418
sorry did not know what bits to write so wrote most of em on here.
basicly how do i get it to work again and how do i reprogram it to work? is there a code needed etc? thanks
hi post the numbers/letters from below the main fat barcode something like 7700xxxxxxtt123 or 8200xxxxtt123 or the security code like Q123 or T0U123 can be found in a small box then i can help you then mail me at codehelp@hotmail.co.uk
code 6548 you must hold at the end to store the code. Code Entry as Follows:
Switch Radio On - Display Shows " 0000 " with the 1st digit flashing Rotate " Thumbwheel " For Correct Digit Press " " On The Stalk Control To Enter Rotate " Thumbwheel " For Correct Digit Press " " On The Stalk Control To Enter Rotate " Thumbwheel " For Correct Digit Press " " On The Stalk Control To Enter Rotate " Thumbwheel " For Correct Digit If the correct code number is now shown Press And Hold " " Until A Beep Is Heard
This radio is designed to fit Renault vehicles that utilise a seperate display on the dashboard. It cannot be used in other vehicles that do not have this seperate display fitted. The Code number is entered by using the remote steering controls, and not through the buttons on the fascia.
Please note that code entry is only possible when a number is flashing in the seperate display. If the display continually shows "CODE" then the unit may be codelocked and will need to be left switched on up for up to two hours to reset before another code entry attempt is possible.
hi, thanks for the reply, unfortunely this radio is in my vauxhall corsa as it came in it. so i have no steering buttons etc, it has a seperate display, but all it shows when i press the power button is the date press the button again its a blank display..
sounds like its not going to be possible to reset then?
did it work in that car before? if so try to leave it turned on to see if it will reset then like this. FOR NO STEERING CONTROL press the first preset button for the 1st digit, second button for the 2nd digit third button for 3rd digit forth button for 4th digit then press and HOLD button 6 to store. for 10 seconds
left the car ignition on for a few hours to keep the radio powerd but nothing happens when i press any of the buttons, i held all for like 15 secs each but nout happened. and yea it did work in this car before, last owner of the car must of fitted it i dont know.
any ideas? checked all fuses and they all seem fine, there is power to the radio but it dont do anything