I briged my visonik amp to where according to the markings said to bridge it +L on Left side and -R on RIGHT side It seemed to beworking fine until i blew a fuse when i raised the volume i went and bought new fuses and was told to use a 40A i did and after that the amp shut down and got stuck in protection mode when i would raise volume
So i check all my connections +/- On the power side and check all speaker wire's nothing was abnormal so i turned system on again with all speaker wires removed including RCA Inputs hooked up first the RCA- System ok Left speaker wire- sound good /sys ok Right speaker wire - sound good /sys ok Then I BRIDGED the left and right ch1 + ch2- / system set in protection After that i set the wires back to the original positions But the right speaker would cause a trip in system everytime and i could only run off of left side what is the issue
1st My 40A inline fuse is good 2nd all connecions correct 3rd speaker hooked up same +/- On right and left my fuse on amp itself "20" good
Number of Channels 2 RMS Power (4 ohms) N/A RMS Power (2 ohms) N/A RMS Power (1 ohm) N/A Bridged RMS Power N/A Total RMS Power Output 400 watts Peak Power Output 800 watts x 1 channel Total Peak Power Output 800 watts Minimum Impedance Unbridged N/A Minimum Impedance Bridged N/A THD at Rated RMS Power N/A Speaker Level Inputs N/A Preamp Outputs 1 pair Built-in Crossover Low-pass (LP) High-pass (HP) High-Pass Crossover Frequency N/A Low-Pass Crossover Frequency N/A Subsonic Filter N/A Signal-to-Noise Ratio N/A Channel Separation N/A Bass Boost 0 - 18 dB Bass/Gain Remote No Fan Cooled No Fuse Rating My power wire is a 6 gage amp wire from battery to amp with 40 Amp fuse im using a 8 gage for ground and 14 gage remote wire with 18 gage speaker wire