I have a visonik V8212 AMP the spects are as follows i am running 2 "10" sub SONY XPLODS XS-L1000B Max peak is 650W i have briged the subs as well they sound good but changed so of the wireing and first i blew the inline fuse u could not tale what Amp it was so i put a 40A in the problem im having is during volume increase it shuts off and flickers like it can't turn on i don't know what i did wrong i just replace speaker wire and bridged the unit here are my speces
Number of Channels 2 RMS Power (4 ohms) N/A RMS Power (2 ohms) N/A RMS Power (1 ohm) N/A Bridged RMS Power N/A Total RMS Power Output 400 watts Peak Power Output 800 watts x 1 channel Total Peak Power Output 800 watts Minimum Impedance Unbridged N/A Minimum Impedance Bridged N/A THD at Rated RMS Power N/A Speaker Level Inputs N/A Preamp Outputs 1 pair Built-in Crossover Low-pass (LP) High-pass (HP) High-Pass Crossover Frequency N/A Low-Pass Crossover Frequency N/A Subsonic Filter N/A Signal-to-Noise Ratio N/A Channel Separation N/A Bass Boost 0 - 18 dB Bass/Gain Remote No Fan Cooled No Fuse Rating My power wire is a 6 gage amp wire from battery to amp with 40 Amp fuse im using a 8 gage for ground and 14 gage remote wire with 18 gage speaker wire
that was very hard to follow. Next time, please check your spelling, and use some punctuation. thanks.
It sounds, if I understood you, like the gain on the amplifier may be turned up too high. Turn it down to below half way, and see if things improve. If the amp works properly that way, and you just don't have enough output, you need a bigger amplifier.