Amp installation question for aq1200d

blake New member Username: Siberian350z Post Number: 2 Registered: May-10	Posted on Tuesday, May 04, 2010 - 20:53 GMT so i am ordering a wiring setup from knukonceptz. I have a aq1200d and am wondering if 4 gauge will work or if the 0/1 is completely needed. I am in a 350z so its not much distance. I dont want a fire though.
GlassWolf Platinum Member Username: Glasswolf Columbia, SC USA Post Number: 13267 Registered: Dec-03	Posted on Tuesday, May 04, 2010 - 23:51 GMT at a shorter distance (say 12 ft or under) 4g should be fine @ 120A draw, which is the most you'll get with that amp. typical use will be much less.
mlstrass New member Username: Mlstrass Illinois Post Number: 5 Registered: Jun-07	Posted on Thursday, May 06, 2010 - 19:16 GMT 1200D has 4g inputs....
GlassWolf Platinum Member Username: Glasswolf Lexington, SC USA Post Number: 13312 Registered: Dec-03	Posted on Thursday, May 06, 2010 - 20:03 GMT which is fine for short runs to a distribution block that has 1/0g in, and 4g out, if you run more than one amplifier.
mlstrass New member Username: Mlstrass Illinois Post Number: 6 Registered: Jun-07	Posted on Thursday, May 06, 2010 - 20:05 GMT 4g is fine for the run from the batt/alt to the amp. I've installed several of them and as you mentioned they will rarely if ever draw the full 120A...