Need wiring diagram (cant find it)

 

Bepro
Unregistered guest
I pulled a Clifford Solaris G4 security system w/remote start and keyless from my cousins vehicle to put in mine, but cannot find the wiring diagram anywhere. I would really appreciate it if somebody could tell me where it is; I really dont want to throw this alarm away.
 

Bronze Member
Username: Erus37

Hollywood, Fl USA

Post Number: 11
Registered: Oct-04
Wiring Description for the 24-Pin Connector
Pin Wire Color Con nects to
1 White/Blue Remotely Adjustable Dual-Zone Piezo Sensor input
2 White/Violet Pulse out before remote start (-) and upon disarming
3 Black/Gray RPM input
4 Blue/Green Reverse light input (+)
5 White Valet switch input (-)
6 Orange Optional sensor input
7 White/Black Hood trigger input (-)
8 Gray/Yellow Trunk trigger input (-)
9 Blue/White Brake light input (+) (and relay shown if manual transmission)
10 Black Ground for Dual-Zone Piezo, optional sensor, LED and valet switch
11 Red Power for Dual-Zone Piezo, optional sensor
12 Black Ground (-)
13 Gray/Green Door lock output (+) or (-)
14 Green Armed output (-)
15 Violet/White Pulse out after remote start (-) and upon arming
16 Gray/Violet Auxiliary A output (-)
17 Gray/Orange Door unlock (+) or (-)
18 Red Battery (+) with 5-amp fuse
19 Violet LED output
20 Yellow Siren (-)
21 Blue/Black Heater 2 relay output if needed (-)
22 Brown/Red Interior light supply input (+) or (-)
23 Gray Door trigger (+) or (-)
24 Blue/Orange Negative out when started
Wiring Description for the 12-Pin Connector
Pin Wire Color Con nects to
1 Red Battery (+) with 30-amp fuse
2 Gray Heater/AC output
3 Green/Blue Coil side - ignition (+) (and relay shown if manual transmission)
4 Red Battery (+) with 30-amp fuse
5 Red Battery (+) with 20-amp fuse
6 Brown Parking light output (+)
7 White/Green Key side - starter input (+)
8 Orange Accessory output
9 Brown Parking light output (+)
10 White/Blue Starter side - starter output (+)
11 Not used Not used
12 White/Brown Key side - ignition input (+)
 

Unregistered guest
if you find a wiring diagram for your clifford.... Can you let me know were i can find a wiring diagram for a clifford 8000(intelliguard)
 

Unregistered guest
if you find a wiring diagram for your clifford.... Can you let me know were i can find a wiring diagram for a clifford 8000(intelliguard)
 

Unregistered guest
my heater doesn't come on with my remote start
is this a fuse if so where is it
 

Silver Member
Username: Ps1k0

Post Number: 126
Registered: Aug-04
sounds like you missed an accessory wire.
recheck all wiring and make sure you got all accessory and ignition wires.
 

BiggBoiMike
Unregistered guest
i need to know how to hook up mini lamp wires, to the slide switch and battery pack wires....Thanks and if you know please IM me on BiggBoiMike




 

New member
Username: Bernie_h2001

Billings, MT USA

Post Number: 1
Registered: Feb-05
I have an old Clifford Arrow 2 and need a wiring diagram to know what to hook up where. Please e-mail me the wiring configuration at bernie_h2001@yahoo.com. Thanks
 

Unregistered guest
DOES ANY ONE KNOW HOW TO BY-PASS A CLUTCH FOR AN AUTO PAGE REMOTE STARTER,AND WHAT THE BEST WAY WOULD BE.
 

New member
Username: Mickeyslim

CoventryUnited Kingdom

Post Number: 1
Registered: Feb-05
Just bought an old BMW 325 which has the Clifford Arrow 2 alarm system fitted. I have the user manual but no installation instructions as i would like to fit this system to my Saab 9000.
If anyone has this info i would really appreciate it.
Thanks.
 

Silver Member
Username: Ps1k0

Post Number: 164
Registered: Aug-04
you bought a car just for the alarm?
wouldn't it have been cheaper just to get an alarm? :-)

actually, i have a bunch of links to alarm wiring diagrams, but do not have a listing for an arrow 2 alarm. i have an arrow 3.

i can post that if you want it.
 

New member
Username: Mickeyslim

CoventryUnited Kingdom

Post Number: 2
Registered: Feb-05
Thanks Ps1k0 that would be great,I'm sure it will be the same set-up.
I bought the car as a spare for the one I'm fixing-up (mechanically sound but bodywork has had it).
Thanks m8.
 

New member
Username: Jeffsy

Post Number: 1
Registered: Mar-05
hi can anyone help me ,i need a wiring diagram for a clifford arrow 3,to be fitted to a corsa
 

New member
Username: Liteitup1

Toledo, Ohio Usa

Post Number: 1
Registered: May-05
i got a harada hcs870 car starter and lost the wire diagram can anyone help me?
 

Anonymous
 
http://www.drdetailshop.com/deiinstallguides.htm

All Clifford Wiring Diagrams and More !!!!!!
 

Anonymous
 
I have a Clifford Intelliguard 800 IQ Does anyone have a diagram for it? Thanks
 

ryanr
Unregistered guest
The colors posted here by 'MIKE D' apply to the arrow/intelliguards/avantguard/intellipage and so on. The only real differences are when features are different/missing between alarms. Besides that, all the basics apply: pwr, grd, ignitn, starter, door pins (dome lite), hood/trunk pin - the door lock relays are integrated on the IG's and up though - ie, an Arrow 3 will have grey/green&orange for locks, but they're negative trigger only - you supply the relays.
 

Anonymous
 
Hello every one.

I have a Clifford Solaris G4 Car alarm system and I changed the battery on the remote control (transmitter) and I did not know how to program it. Please show me how to do it or you can just send me a link to where there is instruction.

big thanks
 

Unregistered guest
I WAS WONDERING IF YOU CAN SEND ME A WIRING DIAGRAM FOR AUTOPAGE MODEL RS-720LCD
 

bambam
Unregistered guest
I have a clifford concept 300 and have fitted it to my 1996 ford escort. The problem is I don't know how to wire in the central locking. Can anybody help....
 

New member
Username: Nasko_dj

SofiaBulgaria

Post Number: 1
Registered: Jun-05
Hi to everybody, i'm new in this forum but i hope to somebody help me.
I have problem with my car (SAAB 9000). I need wiring diagram of my JETRONIC. If somebody have please help me.
JETRONIC BOSCH 0 280 000 532, 93 89 768 is my electronic unit.

Thanks.
Nasko
 

Kyle J
Unregistered guest
Hey I have a Clifford Intelliguard 800-IQ in my car. I got the car from an insurance auction, and it didn't come with the remote. Does anyone know where I can get one?
 

echo
Unregistered guest
Hi
Can anybody help me,i have a clifford super nova 11 the battery backup alarm housing all broke up so i started to replace it, i put the system in valet mode while i unsoldered the wires accidentally touching the red and black wire the siren made a slight noise and i noticed the valet light off plus i had no power to the system so i started looking for a fuse or where the red wire power source is no luck has anybody got any ideas how i can restore power to the system for it to work,i pulled the brain apart to see if there were any fuses but nothing i have traced most of the wires but no luck.
Thanks
Chris
 

Dave Fuel
Unregistered guest
www.cliffordalarms.co.uk is cliffords only active link that i know of. It's not cheap, but it's guaranteed.


Dave xxcypher elitexx on aim
 

James141414F.
Unregistered guest
I need the manual to program a Harada car starter. I think I have model HRDHCS770. Any ideas?
 

rodas
Unregistered guest
I have just bought a toad ai606 car alarm. The alarm has a total closure option and I need help in where to add this wire to the car. The car has total closure worked off the drivers door BMW 318se.
 

C&L Ranch
Unregistered guest
http://www.drdetailshop.com/deiinstallguides.htm
WIRING DIAGRAMS !!!!!!!!!!!!!!!!!!!!!! FREE
******************************************************************************** ******************************************************************************** ************************************
 

Paul Ruskin
Unregistered guest
The best place for Clifford Is http://www.cliffordalarms.co.uk
They came out to me at home in Huddersfield and fitted a concept 650 for £380.00. I was quoted £500.00 by GAP Security.
 

kingrichard
Unregistered guest
I am in need of remote control car starter keys for a Harada model no. hcs760 system.
 

Anonymous
 
need wiring diagram for clifford supernova.... would be greatly appreciated... Also, if anyone has a remote pad for same alarm, let me know.
 

Unregistered guest
NEED USER MANUAL??? can any body help me i need to no what button is which on my toad full closer alarm model number is a20itc or ai606
 

Anonymous
 
Hi,

I have a Clifford alarm system on my Miata. The other day the battery went dead and now my keyless entry and alarm will not work. Do I need to replace a fuse or reset the alarm? Where would I do it?
 

New member
Username: Russelldean

LAKEWOOD, CALIFORNIA USA

Post Number: 1
Registered: Jul-06
NEED WIRE DIAGRAM 4 AUTOSTART CAR ALARM HARADA HCS-900.THE MANUAL WOULD BE NICER.
 

New member
Username: Kimmie8268

Forest Park, Georgia United States

Post Number: 1
Registered: Aug-06
My husband is trying to find wiring diagram for his ancient Pyramid Gold Series PB-290 car stereo amplifier. He took it out of his truck (after many, many years) and wants to put it in our car. Parts of the wiring diagram are peeled off in some spots from age. Can anyone help? I e-mailed the manufacturer, but so far no response. Also, after he installed the stereo, it sometimes makes a LOUD high-pitched whine when the radio is on. We have had the speakers checked and that doesn't seem to be the problem. Also, when the radio is screaming, the CD player won't function properly and turns off and on. E-mail any help to kimmie8268@yahoo.com. Thanks
 

New member
Username: G999

Post Number: 1
Registered: Sep-06
Hello,
I'm trying to fit a Toad Powerkey to my Nissan Pulsar without much luck!! Does anyone have a wiring diagram or manual that could help me??
Thanks for any help with this!
 

New member
Username: Usm163

Nj

Post Number: 1
Registered: Feb-07
hi im looking for a wiring diagram or specifics for each wire on a HARADA Model# HCS-850. Myself and my tech have been searching for this info to install in another vehicle, but have come up empty handed. Are you able to help me out. My email is USM163@aol.com. Thank you
 

New member
Username: Usm163

Nj

Post Number: 2
Registered: Feb-07
hi im looking for a wiring diagram or specifics for each wire on a
HARADA Model# HCS-850. Myself and my tech have been searching for this
info to install in another vehicle, but have come up empty handed. Are
you able to help me out. My email is USM163@aol.com. Thank you
 

New member
Username: Mattrs

Post Number: 1
Registered: Jun-07
hi all.. im tryin to find a wiring diagram for a clifford arrow 2 alarm. Any one got one or know where i can get one?
email us w1zord@hotmail.co.uk

cheers
« Previous Thread Next Thread »



Main Forums

Today's Posts

Forum Help

Follow Us