ok well i have a Kenwood h/u and 2 12in kenwood subs hooked up to a Kenwood 1000 watt amp. I also have a VOLFENHAG ZX2.2 2.0 CAPACITOR. I have the subs in a parallel with 2ohm load. And when i turn up my system pretty loud i blow the inline fuse. here are the specs Can someone please help me
SUBS Speaker Type Component passive Speaker Diameter 300mm Nominal (RMS) Output Power 400 Watt Max (RMS) Output Power 1200 Watt Response Bandwidth 25 - 800 Hz Input Impedance 4 Ohm Sensitivity 90 dB/mW Magnet Type Ferrite Connectivity Technology Wired Additional Features Silver coated connectors Speaker System Details Speakers Included Car subwoofer driver - 300mm - 400 Watt - 25 - 800 Hz - 4 Ohm - wired Driver Details Car subwoofer driver : 1 x subwoofer driver - 300mm - polypropylene
AMP * 1000 watt peak * Mono class "D" Design * 500 watts x 1 RMS @ 2 Ohms * Built in Low-Pass Crossover Filter: 50 - 200 Hz @ 24 dB per Octave * Adjustable Bass Boost Settings: 0 - 18 dB @ 40 Hz * MOSFET Switching Power Supply * Built in high powered Cooling fan * Speaker Level Inputs * Preamp Outputs * Tri-Way Capable * Infrasonic Filter: 15 Hz - 25 Hz @ 18 dB/Octave * Frequency Response: 5 Hz - 200 hz * Speaker Level Inputs * S/N Ratio: 83 dB * Bass Boost: 0-18 dB * Fuse Rating: 40A x 1 * Dimensions: 11-1/16" L x 9-7/9" W x 2-3/8" H * 300 Watts x 1 RMS @ 4 Ohms
i am not sure..... i had a 30 amp fuse inline on the ground for my amp and my distibutor block has two 30amp fuses as well... but the fuse that blows is the one on the ground wire. I have 8 gauge wire ran from the battery to a distibutor block and 4 gauge wire everywhere else but the amp is grounded with 8 gauge as well
my amp only has bass boost, Lpf, and input senstivity.... what should i have them set on starts ends bass boost 0 18 lpf goes to 50 200 input senstivity 5 0.2