New member Username: Xxadamxxb
Post Number: 1
Registered: Nov-08
|
Posted on i have a Kenwood KAC-9104D and it keeps blowing fuses i have it hooked up to a 12 inch audiobahn and i keep poping fuses wats wrong? |
Gold Member Username: Nd4spd18
Philadelphia,
PA
Post Number: 9032
Registered: Jul-06
|
Posted on Kenwood amps are crap and known for power supply failures, I'd bet on that. |
New member Username: Spl_dude
Jacksonville,
Florida
Duval
Post Number: 2
Registered: Nov-08
|
Posted on wat are u runnjing and wat are the wats on the subs |
Bronze Member Username: Kissdaredevil
Post Number: 49
Registered: Aug-06
|
Posted on check at what ohm your running it at, you probably overheated it |
Gold Member Username: Somedonniedude
Illinois
Braaap MX
Post Number: 2127
Registered: May-07
|
Posted on Does it blow fuses when you turn up the volume or just when the amp initially turns on? |
New member Username: Xxadamxxb
Post Number: 2
Registered: Nov-08
|
Posted on the fuse blow when i turn it up and it starts to bump harder |
Gold Member Username: Somedonniedude
Illinois
Braaap MX
Post Number: 2134
Registered: May-07
|
Posted on Sounds like your running too low of an ohm load. What sub do you have, and how do you have it wired? |
New member Username: Xxadamxxb
Post Number: 3
Registered: Nov-08
|
Posted on i have an audiobahn 1500 rms and 2000 watt peak sub and i dont know wat ohm i have it wired at lol |
Gold Member Username: Nd4spd18
Philadelphia,
PA
Post Number: 9041
Registered: Jul-06
|
Posted on ohm load should make it go into protect.....
Another things could be too small a power wire, what gauge wire did you use |
New member Username: Xxadamxxb
Post Number: 4
Registered: Nov-08
|
Posted on i have 4 gauge is that to small |
Gold Member Username: Nd4spd18
Philadelphia,
PA
Post Number: 9055
Registered: Jul-06
|
Posted on No that should be fine |
Gold Member Username: Somedonniedude
Illinois
Braaap MX
Post Number: 2155
Registered: May-07
|
Posted on Pull the sub from the box and post the voice coil configuration. |