I'm buying a box with 2 12" subs in it, but there is only one power connector on the box for both of them. I have two amps that have enough power for one sub each. Can I safely connect both amps to the one power connector for both subs?
Just pop the subs out and run wires through the box by drilling a hole large enough to get the wires through, make sure to tie a knot in the wire on the inside of the box so it can't pull through and then seal up the holes with some silicone.
Awesome. Thanks for the advice. I had no idea what to do, because this is my first stereo system. I was scared of blowing the pair of subs that I spent almost all of my money on (I'm in high school with no job). Thanks again.
