Hey guys, I am new to this site, but I was told to bring my amp over here and there would be a better chance of it selling.
I have plenty of refs over on caraudio.com's forum, where my name is SeanDub.
Here is what I posted over there:
"Okay, I'm thinking I need a little more power, so I'm looking to get an amp that'll do around 4 - 4.5kw. So, I'm going to post up my 2k6 here and see if there is any interest. I'm thinking about picking up an IA 40.1, pair of 20.1s, pair of AQ 2200s, Memphis 4kw, AB 400.1, AB 500.1, Stetsom 7kd, etc, etc, etc. Therefore, I'd be willing to do a trade + cash for one of those amps if anyone is interested.
There have been some doubts about this amp, and questions about it's reliability for daily use. I can assure you that I have used this amp daily for approximately six months, and I have not had any issues. Also, about 5 of those were at 0.5 ohm, and the other was at 2 ohm. Below are the Stetsom ratings and my own personal clamp test results. The only issue I've had with it is that it is kind of loud. The fan inside of it runs loud enough to be heard when the music is playing at very low levels, but can easily be droned out, and also it can be covered up if placed directly behind a seat.
Ratings from Stetsom:
RMS Power @ 13.8V <0,9% THD Mono 2 Ohms: 3000 Watts Mono 4 Ohms: 2200 Watts Mono 8 Ohms: 1200 Watts RMS Power @ 12.6V <0,9% THD Mono 2 Ohms: 2600 Watts Mono 4 Ohms: 2150 Watts Mono 8 Ohms: 1050 Watts Minimal Input Impedance: 0,2V Total Harmonic Distortion: < 0,9 % THD Signal to Noise: > 90 dB Crossover Frequency LOW PASS: 50 to 15 KHz Frequency Response: (FULL RANGE) 20 Hz to 15 KHz (-3dB) Input Tension: 9 to 16V Power Consumption: 3,3 to 240 A Dimensions : 70 x 280 x 330 mm
My clamp results:
Basically I just spent an hour trying to host or attach this **** excel file. I can't do it, so if someone would like to do it for me, I would greatly appreciate it, or I will email it to everyone. I tried it as a Word doc, but couldn't get it under the size restrictions. I tried it as a .bmp (Paint), but couldn't beat those restrictions either. And I couldn't find a site to host an excel file.
Price: I'm looking for around $600 shipped + PP fees.
Let the lowballing begin."
As far as my clamp results, I also posted a few of the highlights from the testing:
My brothers rd 3250 can do .50 ohms and at .875 they are saying it puts out 3750. Im pretty sure they can run at .50 daily with no problems but check with Steve at RD or Kevin.
RMS power, 0.875 ohm mono 3750w x1ch RMS power, 1 ohm mono 3000w x1ch RMS power, 2 ohm mono 1500w x1ch RMS power, 4 ohm mono 750w x1ch Signal to Noise Ratio >100dB Low pass frequency crossover 35Hz~300Hz Subsonic filter 10Hz~60Hz Bass boost @ 45Hz 0~18dB Phase shift control 0~180 degree Frequency response 10Hz~350Hz (+/- 1dB) T.H.D @ 4 ohm <0.1% Efficiency @ 4 ohm 86% Fuse rating 300A(external type fuse - not included) Input Sensitivity 200mV to 6V (+/- 5%) Dimensions 222(W) x 52(H) x 590(L)mm
And Lowlife I dont own one of those Stetsom 2k6d's. They are too expensive for me. And I did hear about some issues daily Mike but I never checked to see if those issues were legit. But I know some guys who would know. So id make sure everything was ok there before I even considered buying one.