Hey, So i, at this very moment, am wiring my subwoofers to my box because i belive i did it incorrectly before...
I am wiring the subwoofers at 1 ohm and they are Alpine Type R 4ohm DVC 12" ers
I wanted to know if anyone has experience with these subwoofers, and if so could you tell me where to place the bannana clips on them, because i can either place them in the holes at the top of each "press" down thing on the 2 + and 2 - areas where u place the wire due to the fact that they fit in there....
or... i could be placing them in the + and - terminal themselves with the + and - wiring from the box but it would be a tad cramped.....
i dont know how else to explain it, but any help would be nice and thanks alot if so
banana clips on sub1 do the banana clip positive to positive and negative to negative. and same for the other sub.
i believe that should give u a 1ohm load, also in the manual for the subs it explains how to achieve ohm loads that u desire for upto 4 subs if i remember right.
