Wiring Question

tips Silver Member Username: Tips Post Number: 209 Registered: Jan-05	Posted on Saturday, December 15, 2007 - 06:04 GMT I have an amp with these ratings: » 600 W x 1 RMS bridged @ 4 ohms » 300 Wx 2 RMS @ 2 ohms » 200 W x 2 RMS @ 4 ohms I currently have two svc 4ohm subs wired to each channel. Could I bridge the amp to give each sub 300 rms @ 4 ohms?
tips Silver Member Username: Tips Post Number: 210 Registered: Jan-05	Posted on Saturday, December 15, 2007 - 06:07 GMT *I meant that I have two svc 4 ohm subs, ONE wired to each channel.
jesse Silver Member Username: Jesse59672 OKLAHOMA Post Number: 814 Registered: Feb-07	Posted on Saturday, December 15, 2007 - 06:08 GMT wire them in paralell for a 2ohm load. looks like 600wrms @ 2ohm
tips Silver Member Username: Tips Post Number: 211 Registered: Jan-05	Posted on Saturday, December 15, 2007 - 06:17 GMT So bridge the amp, and run the subs in parallel? I'm not sure what that means. Connect the negatives of both subs to the negative of channel one, and the positives of both subs to the positive of channel two?
tips Silver Member Username: Tips Post Number: 212 Registered: Jan-05	Posted on Saturday, December 15, 2007 - 15:43 GMT bump