at the moment i got the subs in a sealed box with one sub to each output ont the amp since theres 2 outputs on the amp. but i'm wondering if i should wire them together and how drastic it kill make in the difference. like right now they got a pretty damn good pure sound but it's like it could use a slight push to make them kick harder. but being alpine type E idk how great they compare to type R's. so i don't want to scream them past thier limits but i do have warrenty's so pushem till the break in how i plays been witha warrenty. atm i'm just wondering how much will i gain wiring them together as opposed to one sup on each output as they are now. the type E specs are
Details:
» 12" 4-ohm subwoofer » Kevlar-treated pulp woofer cone with Santoprene rubber surround » dual oversized Nomex spiders » frequency response: 28-1,000 Hz » power range: 50-250 watts RMS » peak power: 750 watts » sensitivity: 89 dB » top mount depth: 6-1/4" » sealed box volume: 0.8-1.7 cu. ft.
the infinity amp specs are this,
Details:
» mono subwoofer amplifier » 400 watts RMS x 1 at 4 ohms (600 watts RMS at 2 ohms) » CEA-2006 compliant » variable low-pass filter (32-320 Hz, 12 dB/octave) » variable bass boost (0-6 dB at 50 Hz) » Class-D amplifier design » MOSFET power supply » preamp-level inputs and outputs » fuse rating: 25A x 3 » 4-gauge power and ground leads recommended -- wiring and hardware not included with amplifier » 14-3/4"W x 2-3/4"H x 9"D